| How to Create a
Ledger Wall 
Follow these easy instructions for preparing a ledger wall
Carefully consider where you want your new wall to
be.
Sort the stones into three or four piles, according to size. That will make it easier to find the size stones
you will need. Reserve plenty of large stones to use for the wall cap’s.
 |
Dig a trench and lay the first stones.
Remove sod and all other organic material from an area about 3
inches wider than the desired bottom thickness of the wall. Check
with a straightedge to see that the excavation is fairly flat. Lay
a tie stone at either end. Fill space between the outside stones
with tightly packed stones. |
 |
Lay additional courses
As you continue to lay stones, aim to make the courses fairly level. Whenever possible, lay “one on top of two” rather than stacking stones of the same size directly on top of each other. Make sure that the wall leans inward slightly. Every third or fourth course, install tie stones every 2 or 3 feet. Fill any large gaps by gently tapping in small stones. |
 |
Mortar the cap stones
Finish the top with large, flat cap stones that overhang the sides of the wall on either side. Set the cap stones in a 1” to 2” thick bed of mortar. The mortar should not be
visible |
|
