| Retaining Wall Finishing
For the final row you have two options; you can use no
capping modules or the Celtik Capping Modules.
|
|
 |
For a finish without Capping Modules
use the same rectangular
blocks
you used to create the wall.
|
|
 |
For a convex curve use the beveled blocks.
Make sure to strike
the extremities
of the blocks at the back.
|
|
 |
Simply spread concrete adhesive
on the next to last row of the Celtik Wall
and lay the last row
of blocks.
|
|
The Celtik Capping Module
| The Celtik Capping Module is sold separately, this
Module offers a different type of finish, no anchor pins are
necessary. Spread concrete adhesive on the next to last row of
the Celtik Wall and lay Capping Modules over it. |
|
To make a radius lay down the Capping Modules cut side by side...
 |
...measure the distance between
the two blocks, then split this measurement in two, and make a
mark at the end of each block that will meet. |
|
 |
Cut with a concrete saw. |
 |
 |
To make a 90 degree angle with the Celtik Capping Modules
you again have two options; the first is to make a 45
degree cut with the concrete saw.
|
|
The second is to hammer down the right or left side of the
Capping Modules, depending on the case, so that the two showing
faces are similar.
Make sure to knock off the retaining lip lugs at the back of the
block.
Continue our How To Build a Retaining Wall Guide - next section
is Construction of Steps. - Click
Here
|
